This project takes you through all the steps required to get your RAK831 LoRa Gateway module up and running with WiFi as the backhaul.
Use the Phantom YoYo High Sensitivity Water Sensor on the MCP3008 8-Channel 10-Bit ADC with SPI interface.
View images and RGB video play on SPI TFT display using Arduino Nano.
An IoT project with Raspberry Pi 2 that uses a Thermistor as opposed to a dedicated temperature sensor to measure ambient temperature.
A Texas Instruments MSP430 designed to input driver data using ADC, handle logical faults, and output via CAN-Bus using SPI.
Control 8 x 8 (64) LEDs using two 74HC595 shift registers as fast as possible using SPI and PORT access. (Updated 19 Jan, 2019)
Use the eTape Liquid Level Sensor on the MCP3008 8-Channel 10-Bit ADC with SPI interface.
Raspberry Pi has only digital inputs. In this article we read analog data through ADC over SPI.
This project will play sound from Arduino and work the same as Google Assistant with limited commands. voice-controlled automation.
ASIC implementation of the PicoRV32 PicoSoC in X-Fab XH018. It contains two ADCs, a DAC, comparator, bandgap, RC oscillator and other IP.
I need to make ESP8266 work with Adafruit OLED for my project I will update my progress as I accomplish things.
Monitor power supply and start emergency power generator in case of power failure.
Are you tired of looking at spinning hands or plain numbers? This clock gives you the time in English!
A hardware tour of various Linux driver subsystems.
Adapting Adafruit's CircuitPython to use the RFM69HCW Radio FeatherWing on the Zynq-7000 series FPGAs.
A 3D-printed hand-movement controlled Thanos Infinity Gauntlet which does not need superpowers to 'balance the universe. 😏
This project is what I did in my free time last year. I hope that it can give you a demonstration of the applications of the STM32 Board.