A simple and zero cost way to add JTAG, I2C expansion, and UART to your hardware.
Get started developing with the PIC-BLE and AVR-BLE development boards.
First article in series about Line Following and Lane Following with CV
Hello everyone! In this article I’m building a bluetooth controlled robot with Arduino. It can be controlled with an Android phone.
MCP23017 BoB with DIN rail mounting and proper wire to board connectors and indicator LEDs.
I'm working on a development board based on the NXP MK26FN2M0VMD18 chip with 2 MB program flash and SDRAM controller, SDHC in a nice MAPBGA.
In this project we are going to interface one dot matrix LED display with AVR(Atmega16) microcontroller.
Learn how to use your micro:bit for programming the RGB LED integrated into the Color Organ of Snap CIrcuits.
In this project we are going to make Atmega16 based traffic light project. Here we have taken one 7 segment and 3 LEDs to denote the signals
This blog post will explain how to setup and run a Hello-World program in Microsoft Azure Sphere MT620 for first time
Here in this tutorial we're going to tell you about how you can interface atmega16 microcontroller with 16*2 LCD in 4 bit mode.
Usage of inductive sensing (MagSense) by Cypress' PSoC4700S to measure contactless the speed of my Gyro Twister (Powerball).
Learn how to program the micro:bit to turn the DC Motor (M1) of Snap Circuits on and off with the help of the NPN Transistor (Q2).
Start exploring your new development board in less than 30 seconds!
Builds on the project Mini But Mightyu, the MiniZed and Vitis for Motor Control using the built in accelerometer to control the speed.
Run Golang on this old but still popular 8-bit AVR microcontroller.
Here in this tutorial we have transmitted data from microcontroller to PC using one of the UART of STM32l100 mcu.
How to convert from analog to digital signals and vice versa using simple Python on microcontrollers.
Print this device to evaluate a 3D Hall effect sensor in an angle + depth setup.
This is a little demo with Seeeduino XIAO - Arduino microcontroller. The demo uses 4 modules. 2 sensors, 1 switch, and 1 OLED display.
Detect rain using together Digi Xbee3 and rain drop sensor.
Learn how to program the micro:bit to turn the Lamp (L1) of Snap Circuits on and off with the help of the NPN Transistor (Q2).
If you want to upload hex file or if you want to set your fuse in AVR then you no need to buy a programmer, you can do it with arduino.
Looking at the different micros from STM and comparing them to each other along with an Arduino UNO, converting an STM32 board to an Arduino