AVR-HV2 is an Arduino-based high voltage parallel programmer for AVR microcontrollers.
Use the FuPy project to load a RISC-V or other SoC softcore on the MATRIX Voice's Spartan-6 FPGA programmable through MicroPython.
Use the ATmega328P's 8-bit timer and prescaler to implement custom timed events, rather than relying on millis() or delay().
MCP23017 BoB with DIN rail mounting and proper wire to board connectors and indicator LEDs.
Get started developing with the PIC-BLE and AVR-BLE development boards.
Autonomous beehive monitoring system : indoor & outdoor temperature & humidity, air pollution, hive's weight and bees behavior analyzing.
I'm working on a development board based on the NXP MK26FN2M0VMD18 chip with 2 MB program flash and SDRAM controller, SDHC in a nice MAPBGA.
Want to add your board to Microsoft's Fantastic Education Platform MakeCode and need a hand doing it? Check this out.
First article in series about Line Following and Lane Following with CV
An innovative implementation of a logic signal acquisition and analyzer unit based on the FlexIO peripheral of new Crossover MCU.
A simple and zero cost way to add JTAG, I2C expansion, and UART to your hardware.
Bringing i. MX RT1010 EVK (MIMXRT1010-EVK) and the MCUXpresso SDK to STEAM (Age 6-16) Education: Scratch/Blockly
Hello everyone! In this article I’m building a bluetooth controlled robot with Arduino. It can be controlled with an Android phone.
Be reminded to get up by using loud sounds from your Stand-Up Alarm Chair. Stand up to sitting down and improve your health!
Create your own giant RC servo using this UMC! add a potentiometer to a motor, plug it in and you're as good as done ;-)
In this tutorial we have explained you about how can we interface 8051 microcontroller with ds1307 RTC.
You'll learn how to build your Active Low Pass Filter RC applied in Projects with Arduino