Get started developing with the PIC-BLE and AVR-BLE development boards.
A simple and zero cost way to add JTAG, I2C expansion, and UART to your hardware.
First article in series about Line Following and Lane Following with CV
I'm working on a development board based on the NXP MK26FN2M0VMD18 chip with 2 MB program flash and SDRAM controller, SDHC in a nice MAPBGA.
MCP23017 BoB with DIN rail mounting and proper wire to board connectors and indicator LEDs.
Hello everyone! In this article I’m building a bluetooth controlled robot with Arduino. It can be controlled with an Android phone.
In this project we are going to interface one dot matrix LED display with AVR(Atmega16) microcontroller.
Learn how to use your micro:bit for programming the RGB LED integrated into the Color Organ of Snap CIrcuits.
Learn how to create a circuit to increase the electrical current of the Arduino pins to activate loads that need more electrical current.
Program the ESP32 on your MATRIX Voice over WiFi using the Arduino IDE, and utilize it as a standalone satellite device.
When the reset button is pressed, the board will take an image, store it to the microSD card and it will then go back to deep sleep.
In this project we are going to make Atmega16 based traffic light project. Here we have taken one 7 segment and 3 LEDs to denote the signals
Go beyond the Arduino with this customizable Uno template. Take your prototypes to the next level!
This blog post will explain how to setup and run a Hello-World program in Microsoft Azure Sphere MT620 for first time
A line follower bot which can detect gas leaks and high temperature in a typical household and raise an alarm.
Track your position and view your full route on a map!
In this article, you will learn how to use the world's smallest Arduino to communicate with the Nokia 5110 LCD.
Library to use I2C PCF8575 IC with Arduino and ESP8266. This IC can control until 16 digital devices like button or LED with only two pins.
Use an ISP programmer and Atmel Studio to flash a blink program to an ATtiny13A, which has just 64 bytes of memory!
You'll learn how to create a system to monitoring the soil moisture level of the plant and inform at the users to irrigate the plant.
In this project, you'll learn how to create a system that must be able to detect a malfunction in an SD card and to inform on an LCD.
Run Golang on this old but still popular 8-bit AVR microcontroller.
Would you like to add finger print to your project? Here is a simple tutorial to help you achieve that!
Here a tutorial on E32 LoRa (Long Range) device very cheap and very long range (from 3Km to 8Km). Start with specs and basic usage.