Want to add your board to Microsoft's Fantastic Education Platform MakeCode and need a hand doing it? Check this out.
Get started developing with the PIC-BLE and AVR-BLE development boards.
A simple and zero cost way to add JTAG, I2C expansion, and UART to your hardware.
First article in series about Line Following and Lane Following with CV
AVR-HV2 is an Arduino-based high voltage parallel programmer for AVR microcontrollers.
Create your own giant RC servo using this UMC! add a potentiometer to a motor, plug it in and you're as good as done ;-)
Use the ATmega328P's 8-bit timer and prescaler to implement custom timed events, rather than relying on millis() or delay().
I'm working on a development board based on the NXP MK26FN2M0VMD18 chip with 2 MB program flash and SDRAM controller, SDHC in a nice MAPBGA.
Use the FuPy project to load a RISC-V or other SoC softcore on the MATRIX Voice's Spartan-6 FPGA programmable through MicroPython.
MCP23017 BoB with DIN rail mounting and proper wire to board connectors and indicator LEDs.
Autonomous beehive monitoring system : indoor & outdoor temperature & humidity, air pollution, hive's weight and bees behavior analyzing.
An innovative implementation of a logic signal acquisition and analyzer unit based on the FlexIO peripheral of new Crossover MCU.
Hello everyone! In this article I’m building a bluetooth controlled robot with Arduino. It can be controlled with an Android phone.
Bringing i. MX RT1010 EVK (MIMXRT1010-EVK) and the MCUXpresso SDK to STEAM (Age 6-16) Education: Scratch/Blockly
Be reminded to get up by using loud sounds from your Stand-Up Alarm Chair. Stand up to sitting down and improve your health!
Learn how to program the Color Organ of Snap Circuits to slowly switch through the colors of the rainbow.
Demonstrating a bug-free Soft Finite State Machine by using STM32 Nucleo144 Dev. Board and Adacore through GNAT
In this project we are going to interface one dot matrix LED display with AVR(Atmega16) microcontroller.
Learn how to use your micro:bit for programming the RGB LED integrated into the Color Organ of Snap CIrcuits.
My PCB Christmas ornament gift for family and friends.
Connect your microcontroller to the internet by adding ESP8266 WiFi module!
VFD tubes are a good alternative to Nixie Tubes, especially in retro clock projects. Read about how they can be used with an Arduino.
UltrasonicEyes is a fun and quirky project you can place somewhere and watch as it looks at things moving around in front of it. Freaky!
Minimalist cars race with a strip of smart LEDs and two switches.