Creative creator
Published © CC BY

Simple Inverter Circuit

This is an easy inverter circuit based upon 13007 Transistor. the essential Inverter works on the Push-Pull configuration.

BeginnerFull instructions provided1 hour869
Simple Inverter Circuit

Things used in this project

Hardware components

13007 TRANSISTOR UTSOURCE
×1
330 OHM RESISTOR UTSOURCE
×1
220V TO 12-0-12 TRANSFORMER UTSOURCE
×1
12V BATTERY UTSOURCE
×1
15W LED BULB UTSOURCE
×1

Hand tools and fabrication machines

SOLDERING IRON UTSOURCE
IRON STAND UTSOURCE
NOSE PLIERS UTSOURCE
FLUX UTSOURCE

Story

Read more

Schematics

Step 1

Bend the 13007 Transistor Pins and tin the wires for Better Soldering.

Step 2

Connect the T1, T2 Transistor’s Emitter together for the 12v inverter circuit.

Step 3

​Now connect 330 Ohm resistor as shown within the Figure. One Transistor’s Base is going to be connected with the Collector of another transistor. And other the other way around.

Step 4

​Connect the T1, T2 Transistor’s Collector with the middle tap Transformer. during this case, The transformer corner points are going to be utilized. the middle tap i.e. middle pin won't be connected during this 12v to 230v inverter circuit diagram.

Step 5

Now Let’s mention Input power. Here i will be able to use a 12V LEAD ACID BATTERY. you'll also use other batteries like Lipo, LI-on also . the middle tap point of the Transformer are going to be used for the +12v supply. The Emitter pin of the Transistor is for the GND or the -ve.

Step 6

Now connect the External Load with the Secondary of the Transformer. Here I even have used a 15W LED Bulb as a Load.

Step 7

Let’s test it. Here I even have connected a 12v Battery as a DC Input Voltage Source. Here you'll see the LED is Glowing. So, the circuit works flawlessly.

Credits

Creative creator

Creative creator

22 projects • 3 followers

Comments