Software apps and online services
I am driving an electric car - a smart for two electric drive. The health of the traction battery is essential and is maintained by a battery management system (BMS). It will monitor all 93 cells during charge / discharge and cares about an equally voltage level balance. Normally only service tools can read information from this ECU.
The car is equipped with a GSM modem for accessing status data like state of charge (SOC), the available range and other simple information. For a certain time the modem was in extended mode gathering diagnostic information about the car. Curious about the content I tried to sniff into the CAN bus to know what was transmitted.
Inspired by similar projects for other electric cars - like the Nissan Leaf - I recorded the complete CAN bus traffic while driving or while charging the car. First sniffed streams really included those diagnostic data - but how to decode it?
You will find details about the CAN bus sniffing and reverse engineering in a separate article here.What is Needed
Get the required hardware. On modern cars the physical layer is done via CAN bus. At least two CAN bus shields are available - see component list. You have to connect to the cars diagnostic port - the OBD-connector, so buy a cable or make your own. NOTE: there are two standards for OBD to DSUB-9 cables - pick the right one! See pictures below:
When you make your own cable, it is a good idea to use an old twisted pair networking cable. Use one of those paired wires for CAN-H and CAN-L. This will improve signal integrity. Also DO NOT exceed 1 m in length, to minimize signal reflections.Get Started
Prepare the hardware and find a nice case for the boards.
Download the project from my github repository. See details there for installation. Compile the code and flash it to the Arduino.
Connect to the car and power it up. Start the diagnostics session and get useful info about your battery pack...
Use a spreadsheet program and find out correlating data. For example compare the SOC (State of Charge, from the dashboard) with the real SOC from the BMS. Or plot the cell-voltages and see that some cells are limiting the pack while charging, because they reach the cut-off limit at first...
Improve the code if you want - do your own hacking. The Spakfun shield has a SD-card reader, so you could build your own CAN bus logger.
Or you build a nice frontend / app displaying the data...
I hope this tool will be helpful - Have fun!